Search
  • NPD

    NPD

  • NPD

    NPD

>
The normal operation of automatic CNC lathe conditions to be met, including the installation location, where the ambient tempera

The normal operation of automatic CNC lathe conditions to be met, including the installation location, where the ambient tempera

Page view
[Abstract]:
To ensure the normal operation of CNC automatic lathes, need to meet certain conditions, including the installation location, where the ambient temperature and power requirements.
To ensure the normal operation of CNC automatic lathes, need to meet certain conditions, including the installation location, where the ambient temperature and power requirements.
 
Installation location
 
CNC automatic lathe location should be away from the vibration source, you should avoid the influence of direct sunlight and heat radiation, to avoid affecting the moisture and air. Such as machine vibration source nearby, the machine should be set up around the anti-vibration ditch, otherwise it will directly affect the machining accuracy and stability of the machine, so that the electronic components is bad, failure, affect the reliability of the machine.
 
Ambient temperature
 
CNC automatic lathes ambient temperature should be below 30 degrees photo shows, relative humidity less than 80%. Generally, CNC electric control box with internal exhaust fan or cooling fan to keep the electronic components, especially the central processor operating temperature or temperature difference constant changes very little. High temperature and humidity control system components will result in reduced life and lead to failure increased. Increase in temperature and humidity, dust adhered to the increase in circuit boards generated and cause a short circuit.
 
Power Requirements
 
CNC automatic lathes are generally installed in the machine shop is not only the ambient temperature changes, the use of poor conditions and a variety of electrical and mechanical equipment and more, resulting in large fluctuations in the power grid, so the installation of CNC lathes have a strict control on the supply voltage. Supply voltage fluctuations must be within the allowable range, and remained relatively stable, otherwise it will affect the normal operation of CNC system.

版权所有:扬州乾牛机床有限公司   电话:0514-87282567  传真:0514-87281159    备案号:苏ICP备14038940号-1